2 spær samles med gitterdrager. Git

2 spær samles med gitterdrager. Gitterdrager skal nederst være smigskåret og skal placeres i flugt med facaderemmens yderside. Gitterdrager skal ligeledes flugte med spærhoveds underside.
Spærelementet rejses op, og der monteres opstillingslægte eller montagebeslag på tængerne ca. 1,3 meter over spærfod.
Hvis spærelementet placeres midt på bygning, kan der monteres en opstillingslægte i hver retning.
Inden ophejsning af spærelement placeres et bundt krydsfinérplader på spærelementet. Disse fastgøres midlertidigt med fx skruetvinge.
Kranen skal have en kapacitet, så den kan løfte både spærelementet og pladerne til den midlertidige gangbro.

Resultater (Engelsk) 1:

2 assemble the rafters with grid draws. The grille at the bottom must be smigskåret and shall be placed in flight with its façade strap outer surface. Grid dragons must also align with the spærhoveds subpage.Spærelementet is raised up, and fitted the Setup Batten or brackets on tængerne ca. 1.3 metres above the spærfod.If spærelementet is placed in the middle of the building, can be fitted to a Setup Batten in each direction.Before hoisting of spærelement placed a bundle of plywood sheets at spærelementet. These be fixed temporarily with e.g. screwing force.The crane must have a capacity so that it can lift both the spærelementet and the plates to the temporary walkway.

Resultater (Engelsk) 2:

2 rafters assembled with truss. Truss must be beveled at the bottom and be placed in the path of facaderemmens exterior. Truss must also be flush with spærhoveds underside.
Rafter element is raised and mounted opstillingslægte or mounting bracket on the tongs about 1.3 meters above rafter sheet.
If rafters item is placed in the middle of the building, you can install a opstillingslægte in each direction.
Before hoisting of truss element placed a bundle of plywood to the rafters item. These temporarily secured with eg clamp.
The crane shall have a capacity so that it can lift the truss element and plates to the temporary walkway.

Resultater (Engelsk) 3:

2 block assembled with gitterdrager. gitterdrager bottom must be smigskåret and should be placed in the run with facaderemmens outer surface. gitterdrager must also be spærhoveds underside. spærelementet is raised up, and fitted opstillingslægte or montagebeslag on the pliers approximately 1.3 metres above spærfod. if spærelementet be located in the middle of the buildingcan be fitted opstillingslægte in each direction. before the hoisting of spærelement placed a bundle plywood on spærelementet. these fixed temporarily with e.g. clamp. the crane should have a capacity so that it can lift both spærelementet and the plates to the temporary walkway.